This annular cooling streamline cowl will give the most increase in performance of any singular item. The reductions of drag means not only faster top speed, but you will get to entry speeds much faster and maintain energy better. It gives excellent cooling and can be used with either fixed pitch or constant speed props. Fits stock S-1S firewall and can be use with the 290 through parallel valve 360. This kit saves 8 lbs over the stock cowling. If you combine it with a composite fixed pitch prop, you can save up to 22 lbs!

Kit includes: 

• Left and right cowl halves made of light weight carbon fiber with outlets installed.

• All fasteners to install cowling including oil door hinge and latch

• Heat shield material

• Engine baffle patterns

• Prop extension, spinner and bulkheads

• Screws and nut plates for fixed pitch installation

• Installation instructions

 Fixed pitch kit:                $ 2,880.00*

 Constant speed kit:         $ 2,250.00*

*Note: this kit does not include spinner.

Wolfpitts Special Rod Gear Conversion

This rod gear offers the lowest drag gear available for the Pitts S-1 series airplanes.

By providing a wider track and spring steel legs, your plane will lands more like a Citabria than a Pitts. It works and looks best when used with the Wolfpitts Special Cowling.

Kit includes:

•   2 gear legs with brake torque plates and axle nuts

•   2 gear fairings with attach brackets

•   2 low drag wheel pants with attach brackets

•   Your engine mount modified with gear sockets, all drilling and gear alignment completed.

Rod Gear Conversion Kit:  $ 2,580.00

Wolfpitts Special Tail Group Kit

This kit offers an increase in both rudder and elevator authority. It also gives a beautiful new look to the Pitts S-1 series utilizing the existing vertical fin and horizontal stabilizers.

The kit includes new ready to cover Wolfpitts rudder and elevators. The elevator comes with a servo boosted trim system to lighten the pitch stick forces.

Kit includes:

• Rudder with hinges

• Elevators with hinges and trim tab

• Pushrod and bearings for the trim system

• Trim torque tube for the horizontal stabilizer

• Gap seals

 Complete Tail kit:   $ 2,675.00

Wolfpitts Special Wings

With the use of aerodynamic balanced oversized ailerons, airfoil changes, and increased wing area without increased span. The Wolfpitts Special Wings will out roll and out corner any other wing available. They provide double the roll rate over a stock S1S and their increased performance is like adding 100 hp on the vertical rolls. " I can get a double vertical roll and fly off the top solid with only 155 mph entry, or even a  triple vertical snap!"

 They have a beefed up center section, spruce spars and truss type ribs with stronger compression ribs plywood leading edges, stainless drag wires, laser cut fittings. Ailerons are box spar construction for light weight. They come with all bearings, fittings, pushrods and slave rods.

Ready for cover:             $ 28,500.00

Covered through silver:   $ 38,000.00*

 *Finish painting available with your custom design.